Haiku kernel reached on Raspberry Pi 4

Haiku kernel reached on Raspberry Pi 4

  • mdo  Administrator
  •   News
  •   November 16, 2026

Good news for anyone following the Haiku ARM64 port!

With the current master, a Raspberry Pi 4 now goes from power-on to the kernel without any local patches. It runs on four CPU cores, and the kernel reaches the point where it looks for a boot partition.

The boot chain is U-Boot, then the Haiku EFI loader, then the kernel.

Getting there took three fixes which are all now merged. The kernel log shows scheduler_init: found 4 logical cpus, and secondary cores are running kernel threads.

What does not work yet: the boot ends with PANIC: did not find any boot partitions!

This is expected: there is no SD card driver for the Pi 4 yet, so the kernel cannot mount the boot volume.

That driver would be the next step.

A few practical notes:

  • With no monitor attached, the boot can stop at ExitBootServices. Adding hdmi_force_hotplug=1 to config.txt works around it.
  • Colors may come out with red and blue swapped, depending on the firmware. Adding framebuffer_swap=0 to config.txt fixes it.

Here is a short video of the boot sequence: https://www.haikuinsider.org/files/rpi4.m4v


Powered by Bludit - Hosted by Planet Hoster
© 2025 Haiku Insider